Conairphone TAD1212 Owner's Manual download pdf (Page 6)

6

INSTALLATION (Cont.)

3. Install one 9 volt battery.

4. Replace battery compartment door

screw and connect the AC adaptor.

5. Install a replacement battery once a

year to ensure proper operation of the

power failure protection feature.

1. Plug your telephone into the modular

TEL jack in the back of your unit (Fig. A).

We do not recommend that you

plug a cordless telephone into your unit.

Operation of a digital answering system

may cause interference on your cordless

telephone.

2. Plug the straight end of the cord into

a modular wall jack. Make sure plug

snaps firmly in place (Fig. B).

or

3. With a four prong style jack, simply

Your message LED will flash rapidly

until 9 Volt battery is installed. Your

unit is fully functional - battery is

needed for power failure backup

ONLY.

Connect to Telephone Line

NOTE:

Figure A

use a plug in modular adaptor (see

Fig. C).

NOTE:

The jack RJ11C of the fixed line cord

complies to FCC Part 68.

(Use only SYSTEM TAD1212 AC

Adaptor of Output AC 9V 150mA)

1. Plug AC Adaptor cord into the back

of your unit (Fig. A).

2. Plug AC Adaptor into a standard

120 Volt wall outlet.

3. When your unit is initially plugged in

allow up to 10 seconds for memory

check before initial setup. Three beep

tones will be heard if you attempt to

record an outgoing message before

this period.

Connect to AC Power

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments